Rapid Tooling Success Stories at VistaTek

Here are a variety of tinted-transparent materials all shot from an aluminum tool created by Vista Technologies.
This part was over-molded. The grey material is a ABS/Polycarbonate blend and the blue over-mold material is Santoprene. These parts are used for low-volume production and shot from a 1+1 family aluminum mold.
These parts were made from an Aluminum tool and shot over 40,000 parts out of ABS. This tool was used as a "bridge tool" while the production tool was being built. VistaTek "Bridge Tools" show great benefits and value to keep production and revenues up in the short run.
This meter was made from a 1+1+1+1 family aluminum tool. The clear lens was made from Polycarbonate and the other three parts were made from colored ABS. Again these tools are used in low-volume injection molding (lvim) production.

For additional VistaTek Rapid Tooling success stories, click here.


 






©2010 Vista Technologies LLC - 380 Oak Grove Parkway, Suite 100 - Vadnais Heights, MN 55127 - tel: (651) 653-0400 - fax: (651) 653-0900 - e-mail: parts@vistatek.com



Vista Home Instant Online Rapid Prototyping Quote Rapid Injection Molding Quote in 24 Hours Rapid Prototyping Rapid Tooling | Aluminum Molds for Injection Molding Injection Molding Plastic Production Parts for .